THEO-P1 series Host-based V2X transceiver module
THEO-P1 series
30 x 40 x 4 mm
Highlights
- Automotive grade V2X transceiver module for infrastructure and vehicles
- Compliance with WAVE and ETSI ITS G5 for US and Europe operation
- Single‑channel 802.11p diversity
- Multi‑channel operation
- Communication range of more than 1 km
Product variants
THEO-P173
ITS G5, 802.11p Module, host-based, 2 antenna pins
Product Selection
Highlights
• Automotive grade V2X transceiver module for infrastructure and vehicles
• Compliance with WAVE and ETSI ITS G5 for US and Europe operation
• Single-channel 802.11p diversity
• Multi-channel operation
• Communication range of more than 1 km
Product description
THEO-P1 is a compact, embedded transceiver module that facilitates development of electronics for Vehicle-to-Everything (V2X) communication systems.
This module is offered in automotive grade for applications such as traffic safety, intelligent
traffic management and entertainment. It provides superior performance in comparison with V2X systems based on consumer-grade Wi-Fi chipsets (COTS), especially at high vehicle speeds and in non-line-of-sight conditions.
THEO-P1 includes an integrated MAC/LLC/Baseband processor and the required RF front-end components. It is connected to a host processor through the USB interface.
Features
Standards: IEEE 802.11p – 2010
conformance: ETSI ES 202 663
IEEE 1609.4 – 2010
Frequency band: 5.9 GHz
Antenna: 2 antenna pins for external 5 GHz antennas
Output power: -10 to +23 dBm
Receive sensitivity: -97 dBm
Data rates: 3 to 54 Mbps
Software features
Operating modes: Single radio
Single channel or
Multiple channels
Radio channel measurements: Channel utilization
Channel active ratio
Per-channel statistics
Received signal and noise power levels
Electrical data
Power supply: 3.3 V and 5 V
Power consumption: 4 W (max)
Interfaces
Host interfaces: USB 2.0 and SPI
Other interfaces: GPIO and 1PPS
Environmental data, quality & reliability
Operating temperature: –40 °C to +85 °C
Automotive qualification according to Baseband/radio AEC-Q100 and ISO 16750-4
Support products
The THEO-P1 evaluation kit includes an evaluation board with full access to the module interfaces. The board has SMA connectors for connecting external antennas.
EVK-THEO-P1: Evaluation kit for THEO-P173
Source: u-Blox
